![]() If you changed the protocol, you will need to resume at the beginning (getting button numbers) as they will probably have changed. You will need to restart X (logout & press Ctrl + Alt + Backspace) to have these changes go into effect. Basically, the simplest way to get the scroll wheel to work is to change the "6 7" above to match the two scroll button numbers from xev. If you are already set to that and can't get buttons to respond (or get multiple button events in response to a single click), you probably need to use the "evdev" driver, described near the bottom of this post. If you have unresponding buttons, chances are that you are using the PS/2 or IMPS/2 protocols, which may not allow for as many buttons (or the configuration) that you have, in which case try the ExplorerPS/2 as shown above. Only change the Protocol line if one or more buttons did not respond. The only two lines we are going to touch are the "Protocol" and "ZAxisMapping" lines. Search for "mouse." It should look something like this (although you may have additional lines): Section "InputDevice" It is essentially to have a backup of nf, as messing it up can damage your ability to work to load your window environment. Basically, the "scroll up" and "scroll down"are 2 more buttons on your mouse, so you will need to identify this as well using xev. This will be approximate, but other guides available cover this in great depth if you need more help. Scroll Wheel And Getting Buttons To Respondįirst, get your scroll wheel working, if you have one. Also note if one or more buttons do not respond. The center item is "button X." Make a note of the number that matches each physical button on your mouse. One at a time, single click each button inside the "event tester" window, and note the 3rd line of output from either (or both) of the " ButtonPress" or " ButtonRelease" notices that pop up. Move your mouse cursor over it, and you'll see a lot of output in your terminal don't worry about the output that happens when you move the mouse.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |